The moisture sensor strips can not fail.
Maytag dryer moisture sensor test.
Next place damp clothes into the dryer.
Dry your largest loads faster and evenly with this 9 2 cu.
The first step to test the dryer s moisture sensor is to place completely dry clothes in the dryer and turn the dryer on.
Use fine grit sandpaper to scrub the moisture sensor.
If your moisture sensor is defective the dryer may shut off too early or continue running for a while after the clothes are dry.
Jdfultonii 1 posted.
The moisture sensor strips are nothing more that two metal strips which acts as a conductor.
There are a few basic ways a dryer moisture sensor can work.
It helps detect the amount of moisture in your clothes during the dryer cycle.
It s typically found on the back wall of the dryer drum or in the front near the lint trap.
Most older model maytags use a moisture sensor located on the back of the drum.
To place the dryer in the diagnostic test mode.
As the clothes begin to dry the timer will move and shut off.
A dryer moisture sensor is a useful device that keeps your clothes from being over dried or still wet at the end of a dry cycle.
Dryer moisture sensor bar.
Cleaning your maytag dryer moisture sensor.
The moisture sensors can be easily checked by placing the dryer in the diagnostic test mode.
Locate dryer moisture sensor.
The maytag dryer moisture sensors control the amount of time it takes to dry clothes.
Be sure the dryer is in standby mode plugged in and all indicators off.
This will help remove fabric softener build up lint or any debris that is interfering with the sensor.
This moisture sensor monitors the clothing s moisture level and sends a signal to the control board when the clothes are dry.
Previous topic next topic.
1 5 years.
Maytag moisture sensor test.
When the dryer takes too long or does not dry the clothes the moisture sensor may need to be replaced.
Then turn on the dryer and watch the timer.
This was a test of a test of concept for a moisture sensor that was to be installed into the bottom of the casing of a robotic fish.
It should run for a few moments and then shut down right away.
If you notice your clothes are still wet after an automatic dryer cycle is done you may need to replace the sensor.
