Open the impeller cover and check that nothing is trapped in the impeller.
Maytronics power supply not turning on.
You can program the power supply at any time.
It is possible all the brains of direction and what functions to perform are controlled by the power supply box in that case it most likely would not work.
We had been using it then i shut it off to clean out filter and it will not come back on.
See the relevant section below for more details on each program.
Wait 30 seconds then turn it back on.
Turn the power supply off.
The pool cleaner moves but.
Take it to your local dealer for further testing or call maytronics customer service.
What about damaged filters.
Check the label on your transformer for voltage output and type.
Ensure the power outlet is functioning properly and that it has not tripped the breaker in the fuse box.
Power supply not rated yet our power supply for our dolphin 3001 will not turn on.
Wait 30 seconds then turn it back on.
Plug the power supply into an electrical outlet.
A known exception the robo kleen power supply puts out about 30 volts a c you read correctly a c.
If no program is selected the robot will perform a single cleaning cycle.
You ll know the app is connected if the power supply buttons are overridden in disable mode.
Ensure the power outlet is functioning properly and that it has not tripped the breaker in the fuse box.
Unplug the power supply.
If the psu turns on and the lights stay on the problem is not with the psu.
Check power to the socket and reconnect pool cleaner.
After 1 min connect your smartphone to wifi.
As a result that light shouldn t turn on again until the filters begin to fill up or are full.
Open the impeller cover and check that nothing is trapped in the impeller.
Pair via bluetooth to your dolphin not a neighbor s.
Press the on button the leds will turn on and the robot will start to operate.
We had been using it then i shut it off to clean out filter and it will not come back on.
If the outlet is receiving power.
Unplug the blue cable from the power supply unit psu and turn it on.
To check your maytronics diagnostic power supply use a multimeter set to 200vdc.
Check the full filter light indicator ensuring that it s off.
Output voltage should be about 38 volts d c.
Close the unit casing turn it on and let it run.
Going to start a thread to see if anyone has attempted this.
Check that the power supply is plugged in and turned on check that the power cable is securely connected all the way into the power supply turn the power supply off.
There may be a problem with the blue cable or the dolphin cleaner itself.
Are you happy with what you learned here.
Turn the power supply off.
